hibar  
   
   
 
             
HOT WATER - STATIC
Static Hotwater High-Pressure Cleaner - OIL, GAS & ELECTRIC HEATED

Key Features of the HSC models are:

  • Static hotwater High-Pressure Cleaner-oil-heated
  • Insulated Cabinet for maximum protection ofComponents and long durability
  • TSS-System with Pump off-delay
  • Burner-On Delay 2s
  • 24v Safety-Circuit
  • Leakage-Recognition
  • Unit Total-Switch Off
  • Hours-Counter
  • Low-Water-Cut-Off
  • Flame monitor with photocell
  • Horizontal Heat Exchanger
  • 2 separate Control-panels:
    • Panel 1 for Operator: Unit on/off , Heating on/off only
    • Panel 2 for defined pre-settings by authorized person only for pressure, waterflow, temperature, detergent etc
HSC 723 Technical Specifications
 
Type
Waterflow
(l/h)
Pressure
(bar)
Temperature
(°C)
Connected
Load (kW)
Order
No.
OIL HEATED
HSC 723
300-720
30-120
30-150
1~230V-3.6
52601
HSC 1140
500-1000
30-230
30-150
3~400V-9.0
52702
HSC 1240
500-1200
30-165
30-150
3~400V-9.0
52801
GAS HEATED
HSC 723-ST
300-720
30-120
30-85
1~400V-3.6
534
HSC 1140-ST
500-1000
30-230
30-85
3~400V-9.0
52701
ELECTRIC HEATED
HSC-ST840-18kW
390-660
30-130
30-80
3~4000V-23.0
530
HSC-ST840-24kW
390-660
30-130
30-80
3~400V-28.0
531
HSC-ST1140-24kW
500-1000
30-230
30-80
3~400V-32.0
532
HSC-ST1140-32kW
500-1000
30-230
30-80
3~400V-41.0
533
To Top ==>
DIRT DRIVER - Tamperproof static hot and cold washers
         

The "TAMPERPROOF" Static hot and cold power washer is housed in a strong lockable cabinet manafactured from either zintec or stainless steel. All models would normally be frost protected.

The TAMPERPROOF can be supplied in varying pressures & volumes from the standard single phase 1500psi @ 12 litres per minute through to the three phase models - i.e 2200psi @ 15LPM; 2300psi @18LPM or 3000psi @ 15LPM - all available for either manual push button control or automatic token control.

CUSTOM BUILD

Due to the nature of the TAMPERPROOF product the units can be custom built to any specification - i.e. special sizes; different pumps or motors; with remote control - all available in Painted Zintec or Stainless Steel.

OPTIONS AVAILABLE

  • Single or Twin Cabinets
  • Internal Hose Reels
  • Flame Failure Cut Out
  • Larger Coils for increased heat
  • Insulated cabinets
  • Remote Controls
  • Fleet Colour Scheme
FEATURES STANDARD
TO BOTH MODELS
  • 24V switching for operator safety
  • Thermostatically controlled heat
  • Low Fuel Warning
  • Low Water Warning
  • Lockable control panel-door
  • Thermal overload protection
  • Emergency Stop Button
  • Anti-tangle hose
  • Insulated chimney & rain cap

MANUAL "TAMPERPROOF"

  • Push Button Control
  • Timed Shutdown
  • On/Off High Pressure Chemical
  • Available in painted Zintec or Stainless Steel

AUTOMATIC "TAMPERPROOF"

  • Token Control
  • Adjustable Time Settings
  • CYCLE 1 - Hot Water & Detergent
  • CYCLE 2 - Cold water or Hot water rinse
  • No circuit board control
  • Available in painted or stainless steel
  • Manual Over-ride

 

         
        Technical Specifications
Tamperproof
Specification
Model 100/12
Model 150/14
Model 200/15
Model 160/18
Pump output
1500psi/100bar
2200psi/150bar
3000psi/200bar
2300psi/160bar
Water consumption
12 LPM
15 LPM
15 LPM
18 LPM
Electric Motor
2.2kW/230V/50
4.0Kw/400V/50
5.5Kw/400V/50
5.5Kw/400V/50
Jet Supplied
15 Degree
15 Degree
15 Degree
15 Degree
Jet Sizes Available
15/25/40 Deg
15/25/40 Deg
15/25/40 Deg
15/25/40 Deg
Water Inlet
12.5mm
12.5mm
12.5mm
12.5mm
Input cable
NOT SUPPLIED UNLESS SPECIFICALLY REQUESTED
Water Temperature
80/100 °C
80/100 °C
80/100 °C
80/100 °C
Weight
250kgs
255kgs
270kgs
270kgs
Dimensions
147 x 84 x 54
147 x 84 x 54
147 x 84 x 54
147 x 84 x 54
Chimney
65 cms
65 cms
65 cms
65 cms
         
        To Top ==>